FS: Link G3 Standalone w/harness

[962 kid]

Selling an almost new link G3 ECU with an unterminated loom. Good for 4 cylinder applications.

Asking $800

[962 kid]

Up

[962 kid]

bump, make an offer!

[haggis88]

is there anywhere in Calgary/surrounding that can install/tune with these?

I'm quite interested, but its not easy to find out information on them with regards to Honda applications, since Hondata is so popular people just go with that!

What were you planning to fit it to, and did you have any reference threads to look at?

[sr20s14zenki]

haggis: i can do a harness up for you if you do end up getting this. Give me a pm for information if you wish.

Most of these standalone ecus support most common tigger setups, and high impedence injectors, which would be fine for a honda. Also, these ecus have more inputs and outputs than what you would see on a hondata, allowing for far more aftermarket things to be used from them. The way this is being sold, you would use the flying lead to build an entirely new engine harness.