Fender pulling in Calgary

[civicrider]

I just picked up my new s3 and I was hoping I could fit my vossen cv7 10.5 wheels on the back. Once I mounted one You can see that it sticks out past the fender so I'm weighing out my options of either selling and getting new wheels or finding someone in Calgary to pull my rear fenders out a bit. Who does this in Calgary?

[KRyn]

You should check out Speed Options. I will likely need my front fenders rolled, if I do they will be the shop to do it.

http://forums.beyond.ca/st/354844/fe...od-experience/

[mr2mike]

That's nothing... no need to fender pull.
Camber the wheel and you're good. If you can't camber enough with stock bolts. You can get crash bolts and it'll get you more camber. But I can tell you, you won't need that.

Might need to roll the fender if there's a metal lip under the wheel well.

[civicrider]

The fenders on this car are already rolled so I am good there, made a few calls and no one seems to have a camber kit for this car yet. Ill look into those crash bolts though

[R-Audi]

May cost more, but you could get smaller rubber and stretch to fit?

[soupey]

not sure if your audi is like mine, but my wheels are pretty aggressive too. Original wheel was 19x8.5 et 52 with 225 width tyres.

Urban Expressions convinced me to go wide and pushed a 19x9.5 et 40 rim in with the same tyres. having the tyres stretched helped a bit, above that there was a tab in the wheel well that needed to be grinded down (it was the only point of rub with my setup in with the rears). you could try looking for the same thing before trying to pull the whole fender out...