Help with Command Start 2400/2500

[quidditchfan]

Does anyone know where I can get a wiring schematic or install manual for the Command Start 2400/2500 Remote Starter?? I'm interested in wiring the Command Start into an Avital Alarm System but I don't have an install manual for the remote start and I can't find anything for Command Start listed on the internet. Thanks!

[Strugari]

Let me know the model numbers of each "alarm and starter" module and I will send out the wiring schematic.

:thumbsup:

[quidditchfan]

The alarm system that I have is the Avital 2100 series and the Command Start is the 2500 series. I need the schematics to wire it into the vehicle and on how to wire the two components together to use only one remote instead of two, if that is even possible. I also need to the wriring format for overriding or inhibiting the vehicle's factory anti-theft system, because I have heard that the factory anti-theft can be a problem.

Thanks for all your help!!

Please e-mail info to [email protected]

[quidditchfan]

By the way the model number of the CS 2500 system is 1081462A.

Thanks again!!

[Koeglmaster]

Does any one know where I can get a new remote for my command start It is hooked up in a 2000 ton & country. the remote has three square buttons on it two on top and one in the middle It operates the doors tunk and starter. im not sure of the model number and if need to be programed. Also I got a screeming deal on a 2400 new and I need the install manual.

Thanks

[Strugari]

If you can get me the model number I should be able to help you out.
PM me your address and I will send out the manual for the CS2400.:thumbsup:

[speedboy]

My command start cs2400 suddenly stopped working. The remote beeps twice instead of once and doesn't do anything. Do I have to set any codes...and I don't have any manual or anything. Please help!!..thanx

[Strugari]

PM sent:thumbsup:

[dodgegirlpp]

New to the site so I hope I am posting this in the right place...

Just bought a 3-1 remote starter/alarm/keyless entry , I have never installed one before but am willing to try. I think I figured all the wiring out but am a little worried it won't work because my 89 Jeep Wagoneer has an anti-theft system in it. It's a chip type key that plugs in under the dash. If anyone knows what I am talking about and knows the answer please HELP

[Strugari]

If the security immobilizer is the one from "the Club", you will have to trip the relay with the remote starter to have it work properly. You need to get the name of the anti-theft device. A wiring schematic of the unit would be good as well. I do not see why we cannot make it work:thumbsup: