View Full Version : Can anyone cut me a mdf ring?
vincent-h
01-01-2006, 10:49 PM
I'm currently in the middle of building my sub enclosure and i need to have 1 or 2 mdf rings cut for my sub box.
I was wondering if anyone could do it real quick for me on monday of course I'll pay for supplies and handle the beer or what not!
Thanks a bunch!
Already have the measurements of course ont eh sub manual =\
alpha
01-01-2006, 10:59 PM
talk to futurecivic
vincent-h
01-01-2006, 11:15 PM
thanks i've sent him a PM but if anyone else would like to step forward that would be great!
thanks
Zero102
01-02-2006, 12:02 AM
If you have a router, and a cutting bit deep enough to go through a sheet of MDF, you can make your own jig very easily. Probably cheaper than buying beer for somebody.
I've made lots of them before, they're easy.
Are you building a fiberglass box? Or are you just spacing the sub(s) out?
vincent-h
01-02-2006, 02:05 AM
fibreglass and the problem is i have neither the router now the jig. that's why i thought it most convienient to get someone else to cut one for me
Zero102
01-02-2006, 11:19 AM
I see. As far as the jig goes, I've used a piece of cardboard for it before. Usually I'll use some thin board however. It's super easy to make. However, the absence of a router makes it much more difficult.
vincent-h
01-02-2006, 12:52 PM
you seem to be ale to cut one wanna get one done for me?
Zero102
01-02-2006, 09:48 PM
Haha, wish I could, but I just don't have the time. I'm in the middle of moving, and am working nights at a warehouse. I could draw up the jig if somebody else on here is able to help you out.
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.