04 intrepid updates for command start 290i_C

[tgcan]

Hi just bought a 2004 intrepid and want to install a command start 290i_C. Only need it to start, not open the doors. etc, any one know how get any updates for the wiring and installation? thanks

[silvercivicsir]

your going to need a transponder bypass ie a 555u 556uw or a 555c

12 VOLTS red (40a), pink/black (40a) + ignition harness
STARTER 1 yellow + ignition harness
STARTER 2
IGNITION 1 dk. blue/white + ignition harness
IGNITION 2 green/red + ignition harness
IGNITION 3
ACCESSORY 1 black/orange + ignition harness
ACCESSORY 2 black/white + ignition harness
KEYSENSE lt. blue - ign harn or bcm, black plug, pin 24 The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.

POWER LOCK white/green + bcm, blue plug, pin 5 Lock is positive trigger thru a 2.7K ohm resistor. Unlock is positive trigger thru a 620 ohm resistor. MUST use relays. The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
POWER UNLOCK same wire as power lock
DOORLOCK MOTOR orange 5wi back of junc block, brn plug, pin 3
DOOR UNLOCK MOTOR dk. blue 5wi back of junc block, brn plug, pin 7
DISARM NO UNLOCK see factory alarm disarm
FACTORY ALARM ARM lt. green/orange + bcm, blue plug, pin 13 Arm is positive trigger thru a 1.87K ohm resistor. Disarm is positive trigger thru a 680 ohm resistor. MUST use relays. The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
FACTORY ALARM DISARM same wire as alarm arm
DISARM DEFEAT

PARKLIGHTS POSITIVE black/yellow + back of junc block, gry plug, pin 11
PARKLIGHTS NEGATIVE yellow - switch or bcm, black plug, pin 2 Parking lights are negative trigger thru a 47 ohm resistor. MUST use a relay. The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
HEADLIGHT yellow - switch or bcm, black plug, pin 2 Headlights are negative trigger thru a 220 ohm resistor. MUST use a relay. The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall. Can also use purple (+) at the back of the junction block, gray plug, pin 13 for the left headlight, and purple/red (+) at the back of the junction block, green plug, pin 3 for the right headlight.
HAZARD
TURN LEFT lt. green + back of junc block, brn plug, pin 11
TURN RIGHT tan + back of junc block, brn plug, pin 10
REVERSE purple/black + back of junc block, brn plug, pin 12
BRAKE white/tan + brake pedal switch
PARKBRAKE gray/black - back of junc block, tan plug, pin 1

DOOR PIN see notes - bcm, blue plug The LF door is tan in pin 4, RF door is tan/red in pin 2, LR door is tan/red in pin 1, and RR door is tan/red in pin 10. Use all four wires and diode isolate each. The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
HOOD PIN
TRUNK PIN tan/black - driver kick, harness to rear
DOMELIGHT SUPERVISION yellow - front of junc block, tan plug, pin 4

TACH not dk. green/lt. green ac any ignition coil or fuel injector
VSS any wheel speed sensor
GLOW PLUGS

TRUNK RELEASE black/white + switch or bcm, gray plug, pin 1
SLIDEDOORS
LEFT FRONT UP/DWN lt. blue - white A driver window switch in door
RIGHT FRONT UP/DWN brown/white - purple/white A driver kick, door harness
LEFT REAR UP/DWN dk. blue/white - red/black A driver kick, door harness
RIGHT REAR UP/DWN gray/black - dk. green/white A driver kick, door harness
SUNROOF LIMIT orange - sunroof control module or motor
SUNROOF OPEN/CLOSE dk. green - dk. blue A sunroof control module or motor
MEMORY SEAT 1 pink/red - switch or memory mod under dr seat
MEMORY SEAT 2 pink/white - switch or memory mod under dr seat
MEMORY SEAT 3

HORN black/red - steering column
DEFROST
WIPER brown/white (l), red/yellow(h) + windshield wiper motor

RADIO 12V pink + radio harness
RADIO GROUND black - radio harness
RADIO SWITCH red + radio harness
RADIO ILLUMINATION orange (dimmer) + radio harness
FACTORY AMP TURN ON
POWER ANTENNA dk. green/red + radio harness
LEFT FRONT SPEAKER dk. green - brown/red +,- radio harness If equipped, the amplifier is in the passenger kick panel. Factory Amp Turn-on same as power antenna wire
RIGHT FRONT SPEAKER purple - dk. blue/red +,- radio harness
LEFT REAR SPEAKER brown/yellow - brown/lt. blue +,- radio harness
RIGHT REAR SPEAKER dk blue/white - dk blue/orange +,- radio harness