PDA

View Full Version : FS: ae86 corolla, 20 valve, tons of mods



dansmith11
07-27-2006, 05:53 AM
up for sale is my newly accquired panda hatch.

Fairly new paint, body very clean, only rust is a bit under the hatch gate (not visible from the outside, just undernearth)

car has 148,xxx miles on it, however the rear end, driveshaft, suspension, engine alll came form my levin which only had 100,000kms on it, and all the suspesnion and engine stuff is new anyhow, so mileage doenst really matter :)

- Blacktop 20 valve (unknown mileage, but compression is 185 on all 4 cylinders, oil comes out looking perfect [included a pic of the oil below], valve train looks perfect, burns no oil)
- new timing belt and tensioner
- new water pump
- new t-stat
- running rear wheel drive water lines (so no ugly lines running up over your exhuast manifold)
- TRD rad cap
- Megasquirt standalone (no distributor, so no firewall bashing/cutting was done)
- T3 velocity stacks
- Techno Pro Spirits 20 valve ceramic coated header (no cutting/modded needed, was desinged to fit the 20valve and fit LHD)
- High Flow Cat
- RS*R catback exhuast
- TODA flywheel
- TODA clutch (lots of life left, grabs HARD)
- low mileage transmission, shifts great
- TRD 2-way LSD
- Ground control coilovers (6.1kg) up front
- TRD Japan rear springs (4.3kg)
- Tokico HTS 45 way adjustable shocks
- cusco camber plates
- cusco roll center adjusters
- whiteline 4 way adjustable swaybars
- cusco adjustable lateral bar
- unknown brand strut tower bar
- prothane bushings all around
- Hawk HP+ brake pads
- stainless steel brake lines
- rebuilt calipers both front and back
- new OEM brake master
- dot 5.1 brake fluid
- new rotors all around (brembo blanks up front, forget the make of the rear rotors)
- SSR starshark wheels (14x7, unknown offset)
- Toyo T1R tires (less then 500kms on them)
- roll cage (not installed yet, however i can install it before sale if needed)
- wideband o2 sensor (currently not installed beucase the sensor is broken, control module/display is there, just need to replace the sensor (it uses the sensor off a 92 civic i believe)
- autometer "phantom" tach 3 3/8, reads to 10,000rpm
- omori gauges (oil temp, oil pressure, water temp)
- JDM Zenki front bumper
- seats all re-wrapped in leather (very nice :)) (the drivers seat is missing the plastic seat back though, should be easy to get another one)


most parts have less then 2000kms on them, all brake parts were just installed this week, bushings and suspension work all new with hardly any mileage (all less then 2000kms), engines been inthe car for approx 1000kms


new price, 8500

also interested in trades for a nice clean mr2 ;)


PICS

http://img.photobucket.com/albums/v618/dansmith11/P1010301.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010303.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010312.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010315.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010310.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010311.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010306.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010309.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010308.jpg
http://img.photobucket.com/albums/v618/dansmith11/P1010318.jpg

dansmith11
07-27-2006, 10:57 PM
bump, flexible on price

IhateDomestic
07-27-2006, 11:02 PM
Honestly, I know its a nice tuned respected car... but for 10G's a buyer would rather go for something newer... it's a lot of money, you'd be better off parting out then selling the vehicle seperately.

Cheers!

dansmith11
07-28-2006, 04:01 AM
Originally posted by IhateDomestic
Honestly, I know its a nice tuned respected car... but for 10G's a buyer would rather go for something newer... it's a lot of money, you'd be better off parting out then selling the vehicle seperately.

Cheers!

just becuase you drive a 240 doesnt mean you have to hate on corolla's dude. lol :poosie:

not every buyer is gonna go for something newer, not everyone shares your opinion. but thanks for the useless post :thumbsup:

next time i want advice on how to sell a car, i'll be sure and let u know.

dansmith11
07-28-2006, 07:43 PM
bump, forgot to add some stuff

also the guages will be mouted properly on the a-pillar with all the wiring cleaned up and out of sight as soon as my guage pod comes in

FallenAngel
07-28-2006, 11:31 PM
Bump for Mr. Smith.

dansmith11
07-31-2006, 02:16 PM
bump

dansmith11
08-13-2006, 01:28 PM
bump, new price, 8500

arian_ma
08-13-2006, 02:25 PM
Newbie question but what are those thick metal rods sticking out of the back of the driver's seat? Is that there because of the plastic piece missing?

Cooked Rice
08-13-2006, 10:52 PM
At first I thought it was just something leaning up against the seat, but it looks as if the plastic cover is not there.

blizare
08-14-2006, 08:18 AM
This car would get me in too much trouble :drool:

Prelude-Vtech
08-14-2006, 11:44 AM
Goodness I hope the back part of the seat there is 24karat solid gold.

dansmith11
08-15-2006, 06:09 PM
yes the plastic piece on the back of the drivers seat is missing :P should be easy enough to get one from a junkyard, i can have it repalced before sale if needed.

95golf
08-16-2006, 10:15 PM
part out some stuff?

F.D.S
08-19-2006, 12:49 AM
Check youre pm's

TopGunn
08-22-2006, 09:22 PM
Hows the reliability on this car, is there a lot of problems that come up running this car or is it reliable to a degree

(yeah you got to pay to play)

NismoDrifter240
04-16-2009, 07:59 PM
would you part the rims?

itsjustaCorolla
04-16-2009, 08:04 PM
the thread is 3 years old

talonboi
04-16-2009, 09:49 PM
:facepalm:

smoothessence
04-17-2009, 12:32 AM
http://img122.imageshack.us/img122/4966/gtfo9wj.jpg

banned3x
04-17-2009, 12:42 AM
edit