PDA

View Full Version : Used honda parts where to buy???



Gravy_83
03-28-2007, 12:38 PM
I was told there is a place that sells only used and new honda parts in Calgary but I don't know where it is or what the name is. I think I even bought a front bumper support there when I had to fix my civic like 3 years ago but a friend picked up the part for me back then so I have no clue where it is. ANy help would be greatly apreciated as I need a lower control arm and inner fender and some front fenders if they have em hehe. Anyways any help would be great on this. Also not new to Calgary but haven't been here that long so a street would be great too.

p.s. I searched but couldn't find anything so if it's been asked before I'm sorry.

Seanith
03-28-2007, 12:41 PM
A1 Honda parts

Gravy_83
03-28-2007, 05:14 PM
thanks anyone know where they are located??

Gravy_83
03-28-2007, 05:15 PM
looked it up and it says 1A street is this correct and if it is can someone explain where that is??? I know most of calgary somewhat but never heard of that street

_wrx_
03-28-2007, 05:17 PM
its near chinook. couple minutes away from tunnerworks

rc2002
03-28-2007, 05:18 PM
It's east off of Macleod. I think you can get to it just off 50 Ave.

Usually your best bet is to find parts from beyond people or from junkyards. A1 is going to cost you quite a bit more.

mo_money2supe
03-28-2007, 05:20 PM
It's a couple blocks N of the Real Canadian Wholesale place that's on 58th Ave S. Hope that helps!

IntegraG2
03-28-2007, 06:19 PM
if you are going towards downtown on mac. hang a right, just after the budget...follow the street down and turn right again on 1A street....

gpomp
03-28-2007, 09:28 PM
a1hondaautoparts.com

3G
03-29-2007, 08:28 AM
A1 is a rip offf

Gravy_83
03-29-2007, 10:11 AM
ok then where would I find pretty much all the parts suspension and otherwise for the front passenger side wheel assembly. I found cv axles from someone on here that i will be getting next week. Im just hoping no frame damage and hoping my strut tower mounts werent bent....