BananaFob
04-12-2007, 10:42 AM
Hi guys after a bit of heartbreak with getting my car broken in to, I've decided to sell my RX-7. This was my daily driver but was somewhat of a project as well as it's been put together with parts from over 7 other FC's.
The good:
- Engine and tranny runs well @ 248k
- Full "60K" tune-up done, ie: all fluids, spark plugs/cables, diff lube etc.
- 2.5" straight pipe exhaust with two resonators (not loud)
- Cold Air Intake
- 5-lug conversion w/ 4 piston front calipers
- TII aluminum hood (very desirable)
- 10th anniversary edition leather seats
- Custom black leather interior
- Black trim
- S5 (Kouki) Taillights
- S5 (Kouki) Rear Bumper
- Alpine Deck, + Wired for amp
- Car Alarm
- Fuel-cut toggle switch wired
- Body is in ok shape
The bad:
- Needs a brake bleed
- A bolt broke in the left-hand side headlight assembly, I'm working on getting that fixed so that the headlight will move up/down
- Rear passenger wheel needs new bearings or potentially a new hub. Easy job to do either way.
- A little bit of surface rust around the sunroof and the body of one fender.
- Small dent in passenger-front fender
- Kinda needs a paint job, TII hood and rest of car don't match although it is close
Looking for $1800 OBO
Night shots for now,
Day shots later
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image052.jpg
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image054.jpg
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image057.jpg
The good:
- Engine and tranny runs well @ 248k
- Full "60K" tune-up done, ie: all fluids, spark plugs/cables, diff lube etc.
- 2.5" straight pipe exhaust with two resonators (not loud)
- Cold Air Intake
- 5-lug conversion w/ 4 piston front calipers
- TII aluminum hood (very desirable)
- 10th anniversary edition leather seats
- Custom black leather interior
- Black trim
- S5 (Kouki) Taillights
- S5 (Kouki) Rear Bumper
- Alpine Deck, + Wired for amp
- Car Alarm
- Fuel-cut toggle switch wired
- Body is in ok shape
The bad:
- Needs a brake bleed
- A bolt broke in the left-hand side headlight assembly, I'm working on getting that fixed so that the headlight will move up/down
- Rear passenger wheel needs new bearings or potentially a new hub. Easy job to do either way.
- A little bit of surface rust around the sunroof and the body of one fender.
- Small dent in passenger-front fender
- Kinda needs a paint job, TII hood and rest of car don't match although it is close
Looking for $1800 OBO
Night shots for now,
Day shots later
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image052.jpg
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image054.jpg
https://webdisk.ucalgary.ca/~gkcheung/public_html/Image057.jpg