twosrus order arrived today

[Berg9987]

It only took a week and a day, but my bushing kit, tie rod ends and ball joints arrived today. Should have my rear tie rods and wheel bearings soon too!

http://i150.photobucket.com/albums/s117/Berg9987/MR2/IMG_1334b.jpg

Soon the car will finally be handling as it should!

Cheers,
Berg

[Berg9987]

By the way, does anyone know the best way to get all the old bushings out? I have bearings on the way, anyone have a press i could use to get the old ones out and the new ones in?

Cheers,
Berg

[n1zm0]

torch em out!:devil:

[Berg9987]

Lol, I knew that was comming.....
What about the wheel bearings? Can they be tapped out with a soft faced hammer or is this something that that really needs to be done with a press?

[thinmyster]

twosrus ships extremely quick! got mine last week too

[Berg9987]

Yeah! Twosrus and kbox.ca are quickly becomming two of my favorite sites!

[Berg9987]

I've found some good documentation on replacing the bushings, but nothing on replacing the bearings. Anyone done this?

[Redlyne_mr2]

Ya just torch em, twosrus is fast, very organized as well. I wish more of the mr2oc vendors could follow their example.

[bmeier]

dont torch them, it takes a long time is messy and hazardous to your health. take them to u-wrench.ca borrow their press and it will take 15 minutes tops and cost maybe 15 dollars.

[Berg9987]

I assume that the same press could be used for the wheel bearings.... that would probably be ideal....

[TEAMFaint]

What were the shipping duties like? I'm wanting to order a MBC and two gauges from them pretty soonly..

[thinmyster]

i dont believe there was duties when i ordered my MBC (and i picked up from fed-ex) i know there wasnt when i ordered last although there wasnt much there

Same with berk no duties whoohoo!