gledhill
07-03-2007, 08:16 PM
Vehicle Details
Year: 1990
Make and Model: BMW ALPINA B10
Exterior Color: Red
Interior Color: Black and Grey
Auto or Manual?: Auto
Odometer: 25,000km
Location: Edmonton, AB
Description :
It is time to sell my Alpina B10. It is not the Bi-turbo but still puts out the 254hp and 240 ft.lbs torque.
Since I imported the car from Japan last year I have completed the following.
Replaced:
Fuel Pump
Fuel Filter
Oxygen Sensor
Fuel Pressure Regulator
Thermostat
Front Brake Pads
Front Brake Rotors
Rear Brake Pads
Rear Brake Rotors
Left and Right Rear Pitman Arm
Right Front Upper Control Arm and bushing
Cap & Rotor
Injector seals
Trunk Lid Shocks
Mas Air Flow sensor and attaching boot
Had a Radiator Flush and Oil Change and service 5W40 Lubro Moly Full Synthetic Oil.
The engine was running rough so I had the injectors looked at. They were fine but the seals needed to be replaced. While apart the mechanic completely cleaned out the throttle body as well he adjusted the valves. The car runs smoothly now.
I have invested over $16,000 into the car and am looking to get out $12,000.
I want to sell the car only because my wife wants a new 4runner.
Extras :
Asking Price :$12,000
Contact Information
E-Mail : [email protected]
Phone : 780-233-9197
Pictures :http://www.flickr.com/photos/jrudge/
Year: 1990
Make and Model: BMW ALPINA B10
Exterior Color: Red
Interior Color: Black and Grey
Auto or Manual?: Auto
Odometer: 25,000km
Location: Edmonton, AB
Description :
It is time to sell my Alpina B10. It is not the Bi-turbo but still puts out the 254hp and 240 ft.lbs torque.
Since I imported the car from Japan last year I have completed the following.
Replaced:
Fuel Pump
Fuel Filter
Oxygen Sensor
Fuel Pressure Regulator
Thermostat
Front Brake Pads
Front Brake Rotors
Rear Brake Pads
Rear Brake Rotors
Left and Right Rear Pitman Arm
Right Front Upper Control Arm and bushing
Cap & Rotor
Injector seals
Trunk Lid Shocks
Mas Air Flow sensor and attaching boot
Had a Radiator Flush and Oil Change and service 5W40 Lubro Moly Full Synthetic Oil.
The engine was running rough so I had the injectors looked at. They were fine but the seals needed to be replaced. While apart the mechanic completely cleaned out the throttle body as well he adjusted the valves. The car runs smoothly now.
I have invested over $16,000 into the car and am looking to get out $12,000.
I want to sell the car only because my wife wants a new 4runner.
Extras :
Asking Price :$12,000
Contact Information
E-Mail : [email protected]
Phone : 780-233-9197
Pictures :http://www.flickr.com/photos/jrudge/