NEED HELP... ASAP looking for a lug nut key

[mard]

hey guys im looking for a typical key for my lug nuts soo if any of u member can help me tongiht I would really appreciate it ...
cause I need to tighten my lugs nuts and i need to go to work tomorrow..

I lost my key for my lugs nuts whe ni sold the old car i might have left it there but im in seriouse need of help i will post a pic of the lug nuts and I hope anyone here in the SW can help me out...

Pay you 20 for just bringing it down and helping me tighten it ....

ohh it has 6 indents on the lug nuts as u can see in the pic...

PLEASE ANYONE HELP ME OUT NO PMS
JUST CALL MY CELL 869-7054 NAMES LEE OR JJ

PLZ N THANZ

problem is i cant take the lug nuts off and they are lose and the wheels when i drive just well makes noise and i know its lose casue i took a peek outside my driver side window..

the pic are bad BUT I REALLY NEED THIS TONGIHT soo please anyone ..... help a fellow beyonder out or person i guess...

[variance]

is there a brand name on it? or a serial number?

they all have different keys.

[mard]

hope this helps sorry for bad pic

[mard]

i cant tell im sorry i look at it but i dont see nothing i cant even take it off cause its tight enough that my hand cant take it off but lose for the car ...

[mard]

please help me out one of u guys must have this set of lug nuts

[RX-7_TWINTURBO]

where abouts in the s.w. ? I may have one

[mard]

Cedarbrae .. by woodbine
down by southland leisure center

[RX-7_TWINTURBO]

Ya i just checked and as long as its the same as the pic you posted i do have one, It's just a normal spline drive socket

plus im only up anderson from you

[mard]

ohh thank god.. yah its just a normal one.. my numbers 869-7054 call please n i can give u a direction

[RX-7_TWINTURBO]

Just pm me your address, I wont have any problems finding it

[mard]

u been pm thanx again

[mard]

MODS CAN CLOSE THIS

THANX again for your help I ow you..
like u said "what goes around comes around"

RX-7_TWINTURBO

[RX-7_TWINTURBO]

Nice to meet you, glad I could help