Command Start

[koogle62]

I need to learn how to program a new remote for my command start car starter. Any help would be appreciated. If you can help, e-mail me at [email protected]
Thanks

[Strugari]

If it is any of the 200 series Command Start, follow the sequence below.
1. Open Hood

2. Press the hood switch down and release (The parklights have to come on)
3. While the lights are on press and release the hoodswitch quickly. (The lights should remain on) If the lights do not remain on repeat steps 2 and 3.
4. Press button I on the transmitter until the lights go out.

Close the hood and try your remote starter

[koogle62]

that doesn't seem to be working. I tried to find model # again and the unit is way up under dash-impossible to see model #. The model # on the new remote is CS313. Does that tell me anything??
Thanks

[Strugari]

Do you have a FCC ID # on the back of the remote?

It may be a newer Command STart.

[Strugari]

PM me and I will get you to send me a pic of the transmitter.
That may help in determining which model it is.:thumbsup: