alleycat
02-22-2008, 11:37 PM
I have a '95 Chrysler Cirrus with a command start 270i or 290i. It has been working fine until recently the starter continues turning even after the car is running when you use the remote--It will stop if you push the start button on the remote again or depress the gas pedal.
I have messed around with the programming trying to figure this out and now the doors lock when you start the car and unlock when you turn the key off. The doors also lock when you close the hood sometimes. Weird eh!!I have tried to reprogram to default by flashing the hood pin and holding the Lock/Unlock button until the lights flash but no change. Does someone have a manual with programming instructions for this thing?
I have messed around with the programming trying to figure this out and now the doors lock when you start the car and unlock when you turn the key off. The doors also lock when you close the hood sometimes. Weird eh!!I have tried to reprogram to default by flashing the hood pin and holding the Lock/Unlock button until the lights flash but no change. Does someone have a manual with programming instructions for this thing?