kvanderlaag
12-16-2008, 11:08 AM
SOLD
I have for sale a conversion harness from OBD2b to OBD1, as well as an unused HONDA1 chip kit from Moates.net.
I'm pretty sure the harness is a Frog harness - I can't rightly remember, though. I bought it from a member on here in Edmonton with big plans to chip my stupid P06 for my EJ6 sedan and tune it for MAD TYTE FUEL ECONOMY, yo.
That was the stupidest idea I've ever had.
The chip kit contains the following:
SST 27SF512 Chip
28-Pin Collet Socket
28-Pin Low-Profile ZIF Socket
74HC373 Logic Chip
Jumper Header for J1
1k Resistor
0.1 uF Capacitors
4-Pin Datalogging header
Replacement capacitor for C14 position (preventive measure)
I think I took them off the foam block in the little baggie once to see what was there and then stuck them back in. None of it has been soldered. It's for a through-hole setup for a North American ECU rather than the surface-mount for a JDM one.
Harness is in good shape. Again, I THINK it's a Frog, but I'm not sure. It's a quality piece, anyways.
You can have my P06 ECU if you want it, too.
$90 for all of it.
I have for sale a conversion harness from OBD2b to OBD1, as well as an unused HONDA1 chip kit from Moates.net.
I'm pretty sure the harness is a Frog harness - I can't rightly remember, though. I bought it from a member on here in Edmonton with big plans to chip my stupid P06 for my EJ6 sedan and tune it for MAD TYTE FUEL ECONOMY, yo.
That was the stupidest idea I've ever had.
The chip kit contains the following:
SST 27SF512 Chip
28-Pin Collet Socket
28-Pin Low-Profile ZIF Socket
74HC373 Logic Chip
Jumper Header for J1
1k Resistor
0.1 uF Capacitors
4-Pin Datalogging header
Replacement capacitor for C14 position (preventive measure)
I think I took them off the foam block in the little baggie once to see what was there and then stuck them back in. None of it has been soldered. It's for a through-hole setup for a North American ECU rather than the surface-mount for a JDM one.
Harness is in good shape. Again, I THINK it's a Frog, but I'm not sure. It's a quality piece, anyways.
You can have my P06 ECU if you want it, too.
$90 for all of it.