PDA

View Full Version : command remote starter



Ray Proulx
09-20-2009, 06:13 PM
Hi

I have a remote starter and the car battery was changed. They told me to reset the remote. I don't know how, the remote is oval and has 2 blue buttons on it. One has two dots and the other one has 1 dot can you please send me instruction manual for it. The only number I can see on the board is command start 1996 and 372a5. On the back of the cover it says cs555.

Thanking you inadvance,

Ray

email address is [email protected]

jonnycat
09-21-2009, 03:06 PM
Edit: I thought this was posted in in General section. I was being a dick.

Strugari
09-21-2009, 05:47 PM
Check the battery int the remote first. If it is OK 10.5V or higher, then reprogram the remote.

Open hood.

Push down and release the hood switch.
The parklights should come on.
While the lights are on push and release the hood switch again.
The parklights should remain on (count to 5 seconds to be sure).
Push Button I on the transmitter until the lights go out.
Close the hood and try your remote .:thumbsup: