hammer6423
03-11-2010, 12:08 PM
Hi, I am new to this site and may not be doing everything correctly, bear with me.
I have a 2000 Jeep Grande Cherokee that has the Command Start 290i installed. It worked great all these years then I let the battery run down as the car was not being used. Now when I try to start the car, it starts and runs for a second or two then shuts down. It will do this four times but fail to start.
Can someone offer a suggestion as to what is causing this condition and a suggested remedy.
I would also appreciate it if someone could send me the installation and programming manuals for this system. Please send it to [email protected]
Thanks
Jerry
I have a 2000 Jeep Grande Cherokee that has the Command Start 290i installed. It worked great all these years then I let the battery run down as the car was not being used. Now when I try to start the car, it starts and runs for a second or two then shuts down. It will do this four times but fail to start.
Can someone offer a suggestion as to what is causing this condition and a suggested remedy.
I would also appreciate it if someone could send me the installation and programming manuals for this system. Please send it to [email protected]
Thanks
Jerry