RickDaTuner
05-28-2010, 05:10 PM
Anyone know the contact information for the machine shop that everyone raves about north of Red Deer?
I need to send a block out for boring, and really have not heard anything good about any of the shops In calgary.
I have a good straight block with no taper and is round, but need new holes cut to match a set of 100mm pistons. Final honing is crucial as the rings I will use are of a hardened alloy and will cause oil consumption if not prepped properly.
I am hoping to find a local solution before I decide to ship it out to California.
Thanks Beyond
I need to send a block out for boring, and really have not heard anything good about any of the shops In calgary.
I have a good straight block with no taper and is round, but need new holes cut to match a set of 100mm pistons. Final honing is crucial as the rings I will use are of a hardened alloy and will cause oil consumption if not prepped properly.
I am hoping to find a local solution before I decide to ship it out to California.
Thanks Beyond