PDA

View Full Version : R6 engine light on



trikypenguin
08-23-2010, 07:17 PM
So I left my fan on the other day to cool down my bike and totally forgot about it (dumb i know) and the battery completely died. So I charged it up overnight and turned on my bike today and now the check engine light is on :/ Just wondering if anyone knows what this could be? I plan on taking it in as well, just wondering if anyone could recommend a good bike shop? The bike is a 2007 Yamaha R6

revelations
08-23-2010, 08:09 PM
what code is it displaying in the odometer area?

trikypenguin
08-24-2010, 01:25 AM
18 I believe

Unknown303
08-24-2010, 01:29 AM
Exup servo motor stuck.

That took less than a minute typing into Google. :dunno:

Unknown303
08-24-2010, 01:30 AM
11 - No normal signals are received from the cylinder identification sensor when the engine is started or while the vehicle is being driven.

12 - No normal signals are received from the cranshaft position sensor.

13 - Intake air pressure sensor: open or short circuit detected.

14 - Intake air pressure sensor: hose system malfunction (clogged or detached hose.)

15 - Throttle position sensor (for throttle valves): open or short circuit detected. Throttle position sensor (for throttle valves) coupler connection is loose.

17 - EXUP servo motor circuit: open or short circuit detected or loose connection.

18 - EXUP servo motor is stuck.

19 - Open circuit is detected in the input lead from the sidestand switch to the ECU.

20 - When the main switch is turned to "ON", the atmospheric pressure sensor voltage and intake air pressure sensor voltage differ greatly.

21 - Coolant temperature sensor: open or short circuit detected.

22 - Air temperature sensor: open or short circuit detected.

23 - Atmospheric pressure sensor: open or short circuit detected.

24 - No normal signal is received from the o2 sensor.

30 - Latch up detected. No normal signal is received from teh lean angle sensor.

33 - Open circuit detected in the primary lead of the cylinder #1 ignition coil.

34 - Open circuit detected in the primary lead of the cylinder #2 ignition coil.

35 - Open circuit detected in the primary lead of the cylinder #3 ignition coil.

36 - Open circuit detected in the primary lead of the cylinder #4 ignition coil.

39 - Open ciruit detected in a primary injector.

40 - Open circuit detected in a secondary injector.

41 - Lean angle sensor: open or short circuit detected.

42 - No normal signals are received from the speed sensor.
- Neutral switch: open or short circuit detected.

43 - Power supply to the injectors and the fuel pump is not normal.

44 - An error is detected while reading or writing on EE-PROM (CO adjustment value).

46 - Power supply is not normal.

50 - Faulty ECU memory. (When this malfunction is detected in teh ECU, the fault code number might not appear on the meter.)

59 - Throttle position sensor (for throttle cable pulley): open or short circuit detected. Throttle position sensor (for throttle cable pulley) coupler connection is loose.

60 - Throttle servo motor: open or short circuit detected. Defective throttle servo motor. Malfunction in ECU (servo motor driving system).

Er-1 - No signals are received from the ECU.

Er-2 - No signals are received from the ECU within the specified duration.

Er-3 - Data from teh ECU cannot be received correctly.

Er-4 - Non-registered data has been received from the meter.

trikypenguin
08-24-2010, 11:30 AM
haha thanks, totally skipped my mind to google it :nut: