Zero102
10-22-2010, 08:01 AM
I am modding a computer case at my work and would like to put the company logo on it. There will be an acrylic side panel on the case and I was hoping to sandblast the company logo into the acrylic then edge-light it with LEDs to make it really stand out. Unfortunately, I have no idea where to go here in Calgary to have some sticky paper or just masking paper cut with their logo on it so that I can apply it to the acrylic and only sandblast the parts I want.
Does anybody have any suggestions for a place here in town that can do this for a reasonable price (and possibly on short notice)?
If it can't be done I can just lay masking tape over, trace the design through then peel the parts I want to blast, but I think if I can get computer cut stencils / masks then it will look much better than if I do it by hand.
Does anybody have any suggestions for a place here in town that can do this for a reasonable price (and possibly on short notice)?
If it can't be done I can just lay masking tape over, trace the design through then peel the parts I want to blast, but I think if I can get computer cut stencils / masks then it will look much better than if I do it by hand.