eg skunk2 lca swaybar hole specs?

[suprame]

planning on installing rear swaybar in my eg finally. i have skunk2 lcas with drilled/tapped holes for swaybar endlinks. i look everywhere online but i cant find the specs. so i was just wondering if anyone knew the specs of the size/thread pitch of the hole so i can go grab a couple bolts to install it. thanks

also here is what i am asking for haha
http://www.skunk2.com/images/s2_lrg_lca_swaybar.jpg

[eglove]

standard honda thread pitch m1.5

[suprame]

so ill assume the bolt is a 10mm as well then?

[streethondas]

I think they are 12mm bolts I will double check for you once I get home

[streethondas]

Wow its 14mm bolts...I didn't think they were that big :nut:

[suprame]

Haha I was way off. Thanks a lot man!

[streethondas]

Haha no worries dude...I knew 10mm was too small... Though it would be 12pm forsure, but it went right through the treads, 14mm went in perfectly but it's going to be bitch trying to find dinky looking 14mm lol

[v2kai]

theyre cheap if you dont want the hassle. just got get the oem DC2 Type R rear sway bar bolts from an Acura dealership. that's what I used with my s2 lcas