Intake manifold, throttle body, fuel rail questions

[Crks&Cstls]

I've been recently looking at some intake manifolds, throttle bodys and fuel rails and like the skunk2 ones. But read some bad reviews on them. Was just wondering If anyone has had or used these and what they have to say about them. Or if anyone has any suggestions. I have a B18c1. Thankss =)

[EFHatch]

Very nice quality the skunk2 manifolds.

Just be aware that you will need to get a tune done after to reap any rewards from it.

[89s1]

i've heard a couple instances where the coolant bung on the s2 manifold popped out at high rpm, it makes quite a mess.

jb weld that bung before you put the manifold on imo.

[streethondas]

Yeah skunk2 manifold is really good, it's basically a ported ITR manifold but since you can't fit the itr one... The skunk2 is the way to go and maybe grab a blox 70mm throttle body?

I know blox sucks but I think there TB arnt that bad :dunno:

Your stock fuel rail Is fine unless your planning to run high boost or you want it for the bling bling

[Crks&Cstls]

more so for the bling bling lol :thumbsup: