spyguy
01-23-2004, 02:07 AM
http://autosom.falai.net/clarion/APA1101.jpg
APA1101
• 100W x 1 Channel Amplifier
• Maximum Power Output 150 W
• Continuous Average Power Output 100 W into 4 ohms 20Hz-20kHz @ 0.08% THD
• Typical 2-ohm MONO load 150 W @ 0.8% THD
• Adjustable Bass Extender Control 0-12dB, 30Hz-120Hz
• Adjustable 50Hz-200Hz, 12dB/oct.
• Low Pass Crossover
• Dual Parallel Speaker Outputs
• Line-Level Summing Inputs
• Pulse-Width Regulated MOSFET Power Supply
• Speaker Level Inputs
I have 2 of these amps...
http://autosom.falai.net/clarion/SRM2591.jpg
SRM2591
• 10" Subwoofer Polylaminate
• Cone Die-Cast Aluminum Frame 2", 8-Layer,
• Heat-Resistant Voice Coil
• Rear-Vented Pole Piece
• Butyl-Rubber Surround
• Strontium Magnet
• Gold-Plated Binding Posts
• 500 Watts Maximum Music Power
I have 2 of these subs...
also a subbox built by soundsaround to hold these subs in.
APA1101
• 100W x 1 Channel Amplifier
• Maximum Power Output 150 W
• Continuous Average Power Output 100 W into 4 ohms 20Hz-20kHz @ 0.08% THD
• Typical 2-ohm MONO load 150 W @ 0.8% THD
• Adjustable Bass Extender Control 0-12dB, 30Hz-120Hz
• Adjustable 50Hz-200Hz, 12dB/oct.
• Low Pass Crossover
• Dual Parallel Speaker Outputs
• Line-Level Summing Inputs
• Pulse-Width Regulated MOSFET Power Supply
• Speaker Level Inputs
I have 2 of these amps...
http://autosom.falai.net/clarion/SRM2591.jpg
SRM2591
• 10" Subwoofer Polylaminate
• Cone Die-Cast Aluminum Frame 2", 8-Layer,
• Heat-Resistant Voice Coil
• Rear-Vented Pole Piece
• Butyl-Rubber Surround
• Strontium Magnet
• Gold-Plated Binding Posts
• 500 Watts Maximum Music Power
I have 2 of these subs...
also a subbox built by soundsaround to hold these subs in.