WTB: B-Series and Integra Parts (Head/Seals/Koni/KYB/Manifolds/Etc)

[Joe-G]

Looking to purchase the following parts. Not in a rush, but looking to pick these up throughout the winter. Looking to buy:

- B18B valve seals (Complete set)
- Complete b series vtec top end (GSR or B16, must come with all sensors, manifolds, and throttle body. Must be in working condition.)
- Koni yellows or KYB AGX that are Integra DC2 specific
- Steering wheel hub (Must work with Personal or Nardi)
- 94-01 Integra floor mats
- black rear privacy cover

Thanks!

[Deetz]

pm'd

[Errol.]

Dim_sum has the complete jdm itr floor mat set aswell as a privacy cover

[OriginalGoods]

Fyi ,if your looking for a vtec head I would go with the bseries pr3 cause the p72 gsr will yeild lower compression

[Deetz]

Originally posted by OriginalGoods
Fyi ,if your looking for a vtec head I would go with the bseries pr3 cause the p72 gsr will yeild lower compression

This is untrue.

The PR3 actually yields 0.1 less compression than the P72. The P72 has square quench bowls that raise compression by 0.1:1 and also have better burn properties under boost conditions

[OriginalGoods]

Hmm , If you look at the characteristics of it you can tell that the gsr has more of a open area on the face P72 full circle. pr3 is obround .

[Deetz]

^^^ You have it backwards :P I own both heads, here is the P72

http://i17.photobucket.com/albums/b98/bfrieman/timsparts001.jpg

[OriginalGoods]

Actually ? Oh noo .. Haha XD