anyone takin apart 2 p wheels?( BBS LM's)

[T-Dubbs]

im tossing around the idea, of reversing the mount of the centers of my wheels.
my offset would change from +20 to +8

has anyone done this to their own wheels??
http://img406.imageshack.us/img406/9136/bbslmoutvsin.jpg

[kvg]

It will be a bitch to put air in.:dunno:

[spacerz]

^ nope, it wont interfere because the air nipple is on the lips.

I wouldn't do it op...not a fan of the look.

[T-Dubbs]

im taking them apart to clean them and maybe polish the dish.
i just thought, i might as well since they are apart...
but not written in stone

[tirebob]

I like it and it isn't hard to do, but you may have to buy all new bolts. If I am not mistaken, BBS uses stretch bolts and the suggest replacing them after even single use...

[T-Dubbs]

who sells these bolts? BBS dealers?
I may start and only do the rears, and see how i like them.
the fronts poke out quite a bit more than the rears.
BUT
would there be too much poke?
http://i30.photobucket.com/albums/c319/T-Dubbs/IMG-20110820-00791-1.jpg
http://i30.photobucket.com/albums/c319/T-Dubbs/IMG-20110820-00792-1.jpg

[spacerz]

You can buy the bolts off of tunershop.com. I've had good luck with them when I replaced the bolts for my RS's

[Disoblige]

Too much poke IMO.

[T-Dubbs]

http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00148.jpg
http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00149.jpg



reverse mounted on left

http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00150.jpg
http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00152.jpg
http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00150.jpg
http://i30.photobucket.com/albums/c319/T-Dubbs/Calgary-20111118-00153.jpg