View Full Version : Horns not working on Sparco Steering Wheel...
AaronS13
09-16-2002, 05:01 PM
so, we just installed my new Flash 3 steering wheel on my S13... looks great, but the horns don't work...
we couldn't even manually ground the horn to get it to work, and i have no clue...
I'm using a momo hub meant for the S13, so i honestly don't have a clue whatsoever....
any ideas???????
thanks a lot guys.. Aaron.
turboMiata
09-16-2002, 05:49 PM
First off, what car?
How are you connecting the horn wiring? Usually, there is a "hot" wire running from your horn up the steering column. I would test this by grounding it with a multimeter and checking if it sez 12V. If so, then your wiring is fine and your horn button is fux0red (probably). I suspect your problem is probably with grounding the button to the Momo hub.
Audi Kid
09-16-2002, 06:21 PM
i gotta check the hub becuase where the hub meets your stearing colum is where its grouned.....there should be a little tab pressing on the bottom of your hub!
buh_buh
09-16-2002, 06:24 PM
Originally posted by turboMiata
First off, what car?
S13 = '88-'94 240SX
AaronS13
09-16-2002, 06:31 PM
Originally posted by Audi Kid
i gotta check the hub becuase where the hub meets your stearing colum is where its grouned.....there should be a little tab pressing on the bottom of your hub!
aahhh... so thats what that tab is for :banghead:
ok... i think we have a winner now, that tab wasn't used... time to pull the wheel out again...
and the S13 is 89-94... but close enough:D
Audi Kid
09-16-2002, 11:04 PM
your welcome :)
AaronS13
09-17-2002, 12:26 AM
oh yes... sorry audikid...
thanks a lot... much appreciated...
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.