Projek01
09-19-2012, 10:44 PM
A few months ago, I posted on here about camera sliders. I decided to take the DIY route and ordered makerslide from Inventables.com.
Ordered all the parts and about half of them have arrived. So far, this project should cost about $200-250 with all electronics and hardware. This gives me the following:
1M Slider
Automatic movement of slider
Automated timelapse electronics
http://img.photobucket.com/albums/v306/Projek_01/IMG_4664_zpsc0e5994f.jpg
http://img.photobucket.com/albums/v306/Projek_01/IMG_4661_zpsdf80506b.jpg
Cut 1"X1" 90 degree aluminum and bolted it into the end of the makerslide (tapped threads first)to make the feet. Then 1/4-20 thread tapped into the middle of the slider for a tripod.
http://img.photobucket.com/albums/v306/Projek_01/IMG_4665_zps4b418d9b.jpg
http://img.photobucket.com/albums/v306/Projek_01/IMG_4660_zpsbb1d44c2.jpg
Electronics is slowly coming in. Arduino Uno loaded with miniE powering a stepper motor will be employed.
More to come! Mods can feel free to delete if no one is interested in the end result.
Ordered all the parts and about half of them have arrived. So far, this project should cost about $200-250 with all electronics and hardware. This gives me the following:
1M Slider
Automatic movement of slider
Automated timelapse electronics
http://img.photobucket.com/albums/v306/Projek_01/IMG_4664_zpsc0e5994f.jpg
http://img.photobucket.com/albums/v306/Projek_01/IMG_4661_zpsdf80506b.jpg
Cut 1"X1" 90 degree aluminum and bolted it into the end of the makerslide (tapped threads first)to make the feet. Then 1/4-20 thread tapped into the middle of the slider for a tripod.
http://img.photobucket.com/albums/v306/Projek_01/IMG_4665_zps4b418d9b.jpg
http://img.photobucket.com/albums/v306/Projek_01/IMG_4660_zpsbb1d44c2.jpg
Electronics is slowly coming in. Arduino Uno loaded with miniE powering a stepper motor will be employed.
More to come! Mods can feel free to delete if no one is interested in the end result.