Darell_n
11-23-2012, 04:54 PM
Looking for a welder to work on 1" and 2" 304L stainless piping for a commercial job located inside the town of Cochrane. The job start-up will be approximately February 2013. I will be doing all the fitting myself, depending on the additional cost of the welder supplying their own. System running pressures will be 1700 psi with the longest runs being around 250 ft and total linear footage 2000-3000 ft. (I don't have full site details, yet.)
Thanks. You can reply in this thread as I would like to start a discussion on this. This is my first job using stainless, other than my hobby welding at home.
Thanks. You can reply in this thread as I would like to start a discussion on this. This is my first job using stainless, other than my hobby welding at home.