Its a succesful version of Arash's project.

[schurchill39]

My sister posted this on her boyfriend's facebook page and it made me think of Arash and his 300zx project. I can't say as I am a huge fan of this one but I can appreciate the work that went into it and that he followed through.

http://www.distractify.netdna-cdn.com/wp-content/uploads//2014/04/2171-620x.jpg

http://www.distractify.netdna-cdn.com/wp-content/uploads//2014/04/871-620x.jpg

http://www.distractify.netdna-cdn.com/wp-content/uploads//2014/04/1453-620x.jpg

http://www.distractify.netdna-cdn.com/wp-content/uploads//2014/04/2722-620x.jpg

Full page here (http://news.distractify.com/people/amazing/sports-car/?v=1)

[rage2]

I just saw this on FB and also thought of Arash lol.

[Graham_A_M]

Props to him, I would have never mixed expanding foam with a cars exterior, but its a helluva lot cheaper to use that, and bondo over it, thus sculpting new body panels then using an English wheel to form them out of sheet metal.

He did a lot of decent work to it, problem is, that car is just 8 shades of ugly. I can see why it would garnish so much attention though.

Like, I really dont know what his end vision was, to end up with an obnoxious "baller" type car? or what? :nut:

[spikerS]

ditto

[Sugarphreak]

...

[jdmXSI]

Haha thought the same thing.

[Kloubek]

The guy has some talent. But that car is just ridiculous. That front end is a total mismatched mess. The rear isn't really that bad - save for any rear quarter angle which shows the ridiculous rear wheels.

[4runneron36s]

check out this gem:

http://www.kijiji.ca/v-classic-cars/red-deer/tube-chassis-race-car-project/579388069?enableSearchNavigationFlag=true

Never seen a square tube chassis, but then again I'm more a truck guy than a car guy. Just looks wrong, IMHO