how should i install a c/f front lip?

[88CRX]

there is are no holes predrilled so how do i go about doing this?

i wanna attach it with two screws on each end in the wheelwells.

should i pre drill so the c/f / fiberglass and bumper dont crack? and also, what type of drill bit should i use?

[kanjus_paki]

take the bumper off throw the lip on and drill some holes if the fitment is alright...make sure theyre not too big for the screws you have though

[Seanith]

drill some small pilot holes in both the lip and the spot you would like to mount it on the bumper.. i dont' know how hard it would be to drill through carbon fiber, but i'm sure its more than do-able. Like said, make sure the pilot holes are fairly small. you just want them to be a starting point for the drilling. :thumbsup: