View Full Version : 440CC Injector Install
Weapon_R
12-01-2002, 07:28 PM
I was wondering if anyone has any experiences with this: I want to install some DSM 440CC injectors which are an easy swap for OBD1 processors. The problem is, I read that I need to weld a 10watt resistor in each of the ground wires going into the injectors so that the current does not damage the ecu. I was under the impression that it would have been the power wire that needed the resistor, and not the ground?? Any ideas? I've enclosed a pic to show how i READ its supposed to be done.
Weapon_R
12-01-2002, 08:14 PM
here's the pic sorry
legendboy
12-01-2002, 08:21 PM
$50 and this could all be yours :D
http://www.telusplanet.net/public/legend88/turbo/injector2.JPG
Complete with shrink wraped wires, zip ties and sodered connections. I would suggest buying another set of injector O rings for your install.
Haha, I don't actually remember which way the wire go. I'd have to go and look.
Weapon_R
12-01-2002, 08:50 PM
As opposed to the 5 dollars it would cost me to buy the resistors and solder them on myself??? :rofl:
Is that the right way to put the resistors? Using the ground wire instead of the power? Which wire is ground on the teg Corey?
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.