PDA

View Full Version : Compustar question(issue?)



mr_spooky
01-08-2005, 01:05 PM
I just had a 2W8000FMR installed in a 95 200SX 5 spd, and the command start does not let my car turn over enough times to start it when it's cold..is this something I can set or should I take it back to my installer to have them adjust it? Also, when it does start (when the car is warm already), it idles like it's being starved for fuel or air for 3-5 secs and then idles normally...would that also be related to not letting it turnover enough? Any help would be greatly appreciated.

Strugari
01-08-2005, 04:17 PM
There are two starter wires on the Nissan. It sounds like it needs the second starter wire hooked up. Take it back to the installer and have him check that.
The second starter wire is needed in colder weather.:thumbsup:

mr_spooky
01-08-2005, 04:34 PM
Ok, I will bring that to his attention. Thanks very much! :thumbsup:

gibson79
02-09-2005, 05:47 PM
I encountered the same problem with my compustar system. Did you find out where the second start wire needed to be terminated?