Metal Fabrication?

[Mitsu_Ralliart]

I have a MOMO shift knob that attaches with the rubber adaptor and set screws. I've noticed there is alot of flex in it when shifting hard. I'm looking to get a piece made so that is can screw onto the shifter. All I need is a metal adaptor and then I will epoxy it into place. Anyone know of a metal place or a machinist that can do this? I called a few places and the prices where outrageous.

[T5Bird]

COLECRAFT- 4636 11 St. NE - 403-681-3683

[Mitsu_Ralliart]

Awsome thanks

[frostyda9]

haha holy shyte man....how hard are you shifting :eek:
I use a Momo with the same 3 set-screw attachment and it's always felt solid even when getting slammed through the gates.
Are you SURE the stalk is all the way into the rubber piece and the set screws were torqued down alternately and evenly?