Quantcast
Search Results - Beyond.ca - Car Forums - Automotive Enthusiasts Community

Search:

Type: Posts; User: bigboom

Page 1 of 80 1 2 3 4

Search: Search took 0.52 seconds.

  1. Replies
    20
    Views
    672

    I use these BBB hooks....

    I use these BBB hooks....
  2. Replies
    1,789
    Views
    115,491

    I'm also interested!

    I'm also interested!
  3. Replies
    353
    Views
    16,725

    At this point for true road tubeless I'm going to...

    At this point for true road tubeless I'm going to say no because the high pressures from what I've seen make it difficult for sealant to do it's job, gravel I'm on board with because of the lower...
  4. My Samsung fridge, oven and microwave have been...

    My Samsung fridge, oven and microwave have been junk. Fridge is poorly designed and have had to replace the temperature sensor twice, the oven control board has buttons that randomly stop working,...
  5. Replies
    1,504
    Views
    63,080

    Tire clearance is one reason to go disc, being...

    Tire clearance is one reason to go disc, being able to run 28/30mm tires on a road bike is sublime!
  6. Replies
    353
    Views
    16,725

    I wasn't aware that 4iiii had issues with water...

    I wasn't aware that 4iiii had issues with water ingress, Stages definitely did when they first came out but they changed their seals and that shouldn't be an issue anymore. And yes, that was the...
  7. Replies
    353
    Views
    16,725

    Just ordered this exact combination for a...

    Just ordered this exact combination for a customer and it works just fine. Alternatively, I've got a 6800 crank set with a 4iiii PM on it that I am looking at moving.
  8. All mainstream cranks other than SRAM GXP and...

    All mainstream cranks other than SRAM GXP and SRAM DUB are either a straight 24mm or 30mm spindle, as nutz said the gxp taper down on the non drive side and DUB are 28.99. I wouldn't bother trying...
  9. Replies
    384
    Views
    39,406

    Sticky: Just get spacers to get the proper chainline and...

    Just get spacers to get the proper chainline and a single ring and you are good to go, no need to change hubs.
  10. Replies
    335
    Views
    13,531

    Thanks for the feedback. I'm going to chalk it...

    Thanks for the feedback. I'm going to chalk it up to the salesperson that you were dealing with, just like all places there are good ones and bad/lazy ones. If you're ever looking for a specific...
  11. Replies
    335
    Views
    13,531

    not sure why you feel that way? they are local...

    not sure why you feel that way? they are local independent single store bike shops that have found different niches to operate in, it's not like Bow Cycle is a large multi store shop like The...
  12. Replies
    335
    Views
    13,531

    Kona Honzo AL/DL. Go down to Bow and see if they...

    Kona Honzo AL/DL. Go down to Bow and see if they have anything left from the blue light sale.
  13. Replies
    1,789
    Views
    115,491

    I've had the exact same black spot develop in my...

    I've had the exact same black spot develop in my garage where the drain hole is so it's definitely the truck :p
  14. Replies
    335
    Views
    13,531

    Be careful not to be oversuspended, it really...

    Be careful not to be oversuspended, it really makes riding no fun. Around the moose area I would argue you need no more than 120-130mm of travel with some progressive geometry, more then that and...
  15. There's a lot of bullshit that Sunshine spews...

    There's a lot of bullshit that Sunshine spews just to try and win public opinion. A more educated discussion would have been to spell out what is different between Sunshine's guidelines compared to...
  16. Replies
    1,789
    Views
    115,491

    Mine's not terrible but it is noticeable. Do you...

    Mine's not terrible but it is noticeable. Do you have the FX4?
  17. Replies
    335
    Views
    13,531

    The ripple effect of this is that all north...

    The ripple effect of this is that all north american retailers are going to start raising their prices as they no longer have to deal with retailers that don't need to abide by a minimum price.
  18. Just another sign to show that pro-cyclings model...

    Just another sign to show that pro-cyclings model is broken. ASO makes money hand over fist and teams can't stay afloat with trying to find sponsors. As much as people hate Sky with the money they...
  19. Replies
    870
    Views
    67,693

    It's cause he isn't good at math. The 3x is just...

    It's cause he isn't good at math. The 3x is just Canadian production vs global demand, not an apples to apples comparison.
  20. Replies
    1,789
    Views
    115,491

    I'm in the same boat. Have the power running...

    I'm in the same boat. Have the power running boards and definitely have concerns about them but so far they've been fine, i'm tempted just to lock them in the down position for the winter though.
  21. Replies
    335
    Views
    13,531

    Bow Cycle carries Norco and typically has sales...

    Bow Cycle carries Norco and typically has sales around the holidays where they will give you a percentage of a new bike sale back in store credit.
  22. Replies
    14,013
    Views
    1,673,089

    If you don't have room for this I have one of...

    If you don't have room for this I have one of these and it does the job as without the foot print.
    ...
  23. Had the exact same discussion last week from HOC...

    Had the exact same discussion last week from HOC with a car I was selling. In the end a buyer from Kijiji purchased the car for more than what HoC offered me but I was tempted to go down this route...
  24. Replies
    353
    Views
    16,725

    Check the teeth on your chain ring, could be as...

    Check the teeth on your chain ring, could be as simple as a bent tooth that needs to be straightened and since its a commuter wouldn't have to replace it as you could probably get it back in place.
  25. Replies
    353
    Views
    16,725

    Depends which spindle size you have with your...

    Depends which spindle size you have with your gossamer. I think they made the gossamer in a 24mm spindle and now i think they are all the 30mm spindle. All Shimano cranks run a 24mm spindle so if...
  26. Replies
    1,789
    Views
    115,491

    Is there a difference in these units?/Which is...

    Is there a difference in these units?/Which is the best one to get?
  27. Replies
    353
    Views
    16,725

    I think that's way to high of a pressure. I'm...

    I think that's way to high of a pressure. I'm heavier than you and on 25s I run about 95 psi.
  28. I've got the 3.5 ecoboost.

    I've got the 3.5 ecoboost.
  29. This. My F150 made it to Sicamous and back with...

    This. My F150 made it to Sicamous and back with some light driving around the area with about 100 or so kms till empty this weekend. It is a 136L tank.
  30. Replies
    39
    Views
    1,953

    Something like this happens every GT and the...

    Something like this happens every GT and the problem is how do you fix it? Do you have to set up barriers and security for 100km? I think that's the big issue, as they keep ever increasing distances...
  31. Replies
    39
    Views
    1,953

    This is going to be a pretty cool unfolding of...

    This is going to be a pretty cool unfolding of events with Thomas in the yellow. Curious where Froome is going to try and attack to get it, do they hold off until they are in the Pyrenees? Or try...
  32. Replies
    39
    Views
    1,953

    He's just following proper post crash bike check....

    He's just following proper post crash bike check. Spin the cranks to get the chain back on, a half revolution of cranks would get your wheel spinning like that.
  33. Replies
    39
    Views
    1,953

    I thought it was going to be even more decisive...

    I thought it was going to be even more decisive though, especially when Landa crashed and Bardet had a late flat, but they both chased back on and only lost a few seconds. Too bad for Porte though,...
  34. Replies
    1,504
    Views
    63,080

    There is no one size fits all for people. A lot...

    There is no one size fits all for people. A lot of it is going to come down to what your physiological make up is, do you have more slow-twitch or fast-twitch fibers for your muscle buildup? I...
  35. Yes, I am. Based on your accountant and how they...

    Yes, I am. Based on your accountant and how they do things it can be different in terms of the advice you get as well. It's all going to depend on how his business is set up which I know nothing...
  36. It only makes sense to transfer it to the...

    It only makes sense to transfer it to the business if the vehicle is 100% used for business purposes. If the vehicle gets any personal mileage on them it's a lot more work to charge out the usage of...
  37. Thread: Free air

    by bigboom (view post)
    Replies
    33
    Views
    2,126

    Are you sure that wasn't for the vacuum? I was...

    Are you sure that wasn't for the vacuum? I was there a couple weeks ago and dint notice pay air, they've had a pay box for the vacuum for a while though.
  38. Replies
    353
    Views
    16,725

    It does if you have an xd driver :)

    It does if you have an xd driver :)
  39. Replies
    353
    Views
    16,725

    Oh yeah if it's a 9mm QR then yes you can replace...

    Oh yeah if it's a 9mm QR then yes you can replace it with just a qr head. I shit you not somebody once tried replacing a thru axle with a qr skewer.
  40. Replies
    353
    Views
    16,725

    Torque specs for axles are heavy hand tight...my...

    Torque specs for axles are heavy hand tight...my rule of thumb anyways. And absolutely not, you cannot replace a thru axle with a qr skewer.
Results 1 to 40 of 3174
Page 1 of 80 1 2 3 4