3rd gear run. AFR between 11.5 & 12.5
Some people have said the torque numbers seem a bit low... Anyone know what kind of numbers I should be getting? I know the timing is not optimal yet, I'm working on that.
MH
3rd gear run. AFR between 11.5 & 12.5
Some people have said the torque numbers seem a bit low... Anyone know what kind of numbers I should be getting? I know the timing is not optimal yet, I'm working on that.
MH
On a clear disk, you can seek forever...
looks like your timing map needs a total overhaul judging from your torque curve. are you running the ems?
Machining, Fabricating, Welding etc.
Assuming his boost is stable and timing is same at that TQ level over the RPM range (or relatively close), the large drop in TQ is most likely from A/F ratio being a bit off.
Buh_buh pulled 150ft/lb of TQ, very very flat. Pretty much stayed close to 150ft/lb from 3000-6700rpm. This was at 2psi.
Got a dyno plot with A/F?
Originally posted by SEANBANERJEE
I have gone above and beyond what I should rightfully have to do to protect my good name
your torque should be well over 200lbs
what size of turbo are you running?
and what kind of exhaust are you running and are you still using a cat?
Last edited by redline; 07-04-2003 at 10:06 AM.
T3/T4 .50/.57 trim I think
Originally posted by rage2
Can someone who speaks brown please translate this for me please?
I dont think your torque should drop like that, im pretty sure it goes up or falls and stays the same after vtec kicks in, so say like 5000-6000rpm or so....
http://www.preludeonline.com/showthr...threadid=95293
DannyO
Oh yea, I also met Doris..
I am running the ems.
I haven't touched the ignition map yet, so yes timing needs a bit of work. I'll work on the fuel maps a bit more.
I am running a Greddy Power Extreme exhaust, with the cat. 3" pipes.
I'd like to see a good dyno plot to compare with mine...
MH
On a clear disk, you can seek forever...
Can you email me your EMS file? I'd like to have a look at your maps. Shoot it to [email protected]
Originally posted by SEANBANERJEE
I have gone above and beyond what I should rightfully have to do to protect my good name
Here's buh_buh's 2psi graph. Look how flat the TQ curve is. There's a bit of room for improvement even on this one, but the 2psi tune is temporary till he gets his boost controller.
Originally posted by SEANBANERJEE
I have gone above and beyond what I should rightfully have to do to protect my good name
I will email it to you soon. I didn't have time because of the v8less show...Originally posted by rage2
Can you email me your EMS file? I'd like to have a look at your maps. Shoot it to [email protected]
MH
On a clear disk, you can seek forever...