Drilling through the floor

[core_upt]

Hey everyone,

I have to drill throught the floor of my 89 civic to fit the CRX seats I bought. I have a titanium drill bit to do the job. Is there anything I should be careful of when doing this?? The seats will be bolted on with washers on each side so they don't rip off. Anything I'm overlooking??

Thanks as always!

-J

[ryder_23]

just check underneath to see what u could possibly drill threw, and watch out for wires, etc...

[tommy1223]

what Ryder_23 said. and besure to seal it up with sylicone or soemthing so water wont leak through after it.

[ryder_23]

^
Yeah, maybe even some touchup paint, just to help prevent rsut.

[CRX-R]

Originally posted by core_upt
Hey everyone,

I have to drill throught the floor of my 89 civic to fit the CRX seats I bought. I have a titanium drill bit to do the job. Is there anything I should be careful of when doing this?? The seats will be bolted on with washers on each side so they don't rip off. Anything I'm overlooking??

Thanks as always!

-J

CRX seats should fit into the same holes as the factory civic seats.... no???
But if they don't you want to be really careful within 5" of the door sill.... That'd be your gas line

[rice_eater]

drILL UNTIL YOU GET TO THE OTHER SIDE AND STOP!