FS: Honda B16A2

[freakin]

THIS ENGINE IS SOLD


I've been getting a lot of inquiries about the motor, hoping to repair it, but they're getting scared off by the prospect of machining the block. I've re-writen the add to make it more clear.

Just think of this as a head with a free motor and it'll make a lot more sense. I'm selling the entire motor for the price of the head and you're getting a lot of the little parts that you'll have to buy for a build anyhow.

What you get:
-B16 head (2nd gen), complete and professionally cleaned before installation
-OBD-0 distributor
-AEBS intake manifold
-AEM high flow fuel rail
-New timing belt
-New Type R oil pump
-New water pump
-New timing belt tentioner
-New front and rear main seal
-B series flywheel
-OBD-0 exhaust manifold
-Free JDM 2nd gen B16 bottom end, compete, cleaned, all new bearings, but needs to be bored out (cylinder 3 is out of round)


SOLD





(header NOT included!)

[freakin]

Please note that I do not have a tranny, ECU, harness, axles, or anything else for this motor for sale. This is strictly the engine and the parts that are listed. The head is complete and will have all of the sensors, injectors, solenoid, TB, etc.

[freakin]

Bump, This is essentially a complete motor for the price of a head. If you're building an LS/VTEC, these are the pistons you'd want to put in the LS block. You can get somewhere in the 11:1 compression ratio with all OEM parts by putting the P30 pistons on the LS bottom end.

[freakin]

I found the distributor and dropped the price a bit.

[ShOrT_SiR]

you still has this ?

[freakin]

Yes sir. It's still in my garage. Pm your info an we can set something up.

[freakin]

This is still for sale. This a pretty damn good deal already, but I won't refuse a reasonable offer.

[300zx_007]

part oil pan?

[freakin]

I just threw one out. Oh well. Anyhow, sorry, not parting out the motor. I'm keeping it intact in case someone wants to rebuild it.

[freakin]

The GSR cams are sold. The rest of the head/motor are still available. The head still has the B16 cams on it.

[403ek]

hI there interested in your engine and head please call 403 818 9487

[misterrick]

Originally posted by 403ek
hI there interested in your engine and head please call 403 818 9487

Too bad I'm picking it up tomorrow

[freakin]

SOLD