Looking for some Z32 calipers for my S13. I'm going to be rebuilding them before I put them on, so the condition doesn't really matter. Cash in hand!
Looking for some Z32 calipers for my S13. I'm going to be rebuilding them before I put them on, so the condition doesn't really matter. Cash in hand!
i think jdmsource has a few sets. give them a call.
wow thanks Evan, i didn't even think to call JDM.Originally posted by sr20s14zenki
i think jdmsource has a few sets. give them a call.
I'm going to pick up calipers, rotors and pads for 2 bills flat tomorrow.
I just hope they are 30mm and not 26mm
picked mine up recently from jdm source (im still collecting rotors/pads/lines) but heres the photo i think he still has one more set in stock.
Last edited by KuruptEX; 12-23-2009 at 07:57 PM.
sig kinda deleted by moderator, click here for info
http://my240.epijunkie.com/5_Lug_and...ake_Conversion
apparently everything after 1990 300zx NA was 30mm
The 26 and 32 aluminum look the same, the only difference is the 26mm is dirty and the 32 is clean
anyway to tell the differences by looking at the caliper if its 30mm?Originally posted by sr20s14zenki
The 26 and 32 aluminum look the same, the only difference is the 26mm is dirty and the 32 is clean
sig kinda deleted by moderator, click here for info
Not a clue, i would say just get the stuff and install. Hopefully they arent 26mm, and if they ARE, you trade your 92 300zx TT rotors for 1990 300zx NA rotors, same bolt pattern, just a bit skinnier.
I am by NO means a Nissan guy...I just noticed in the pictures of the Aluminum Calipers...
On the right side piston...above it a "1" on the 26mm and a "2" on the 30mm....I don't know if that is an identifying mark...but maybe something that you can go on??
...@therealarifjina...
haha good eye man, i didnt even see that. It could be, ill have to look at my set on my car. I know it wont be measurements, as 1" is roughly 25mm, and 2" is 51mm.....but it could be a casting number or something, a different caliper would be a different mold....Originally posted by EK 2.0
I am by NO means a Nissan guy...I just noticed in the pictures of the Aluminum Calipers...
On the right side piston...above it a "1" on the 26mm and a "2" on the 30mm....I don't know if that is an identifying mark...but maybe something that you can go on??