Quantcast
Gas tank PDR - Beyond.ca - Car Forums
Results 1 to 3 of 3

Thread: Gas tank PDR

  1. #1
    Join Date
    May 2003
    Location
    Calgary
    My Ride
    DC4, CB750, CB360t
    Posts
    771
    Rep Power
    9

    Default Gas tank PDR

    Looking to have some dents removed from my gas tank. Its a 70s Honda tank so it's a heavy gauge steel. Any recommendations on where I should take it?

  2. #2
    Join Date
    Jul 2004
    Location
    YYC
    Posts
    3,125
    Rep Power
    16

    Default

    Don't know a place but you could DIY. But you gotta be sure it's free of any gas.

    Make some fitting that allows you to put an air compressor on it. Pressure it up (not too much). I'd try 40psi. Then use a torch to slowly heat the dent up. It should then press out.

    I've read this is the way it's done. same goes with exhaust cannister dents.

  3. #3
    Join Date
    Jan 2010
    Location
    calgary
    My Ride
    911 & Cayenne
    Posts
    1,113
    Rep Power
    7

    Default

    I've used DNT on memorial a handful of times, always left very satisfied.
    We stopped checking for monsters under our beds when we realized they were inside us.

Similar Threads

  1. FS: Toshiba PDR-4300

    By CanadianBoy69 in forum Miscellaneous Buy/Sell/Trade
    Replies: 3
    Latest Threads: 11-28-2005, 05:24 PM
  2. Toshiba PDR-4300 Digital camera FS!!

    By SleeperD in forum Miscellaneous Buy/Sell/Trade
    Replies: 5
    Latest Threads: 03-23-2005, 07:06 AM
  3. FS: Toshiba PDR-2300 Digital Camera

    By aka Ferrari F50 in forum Miscellaneous Buy/Sell/Trade
    Replies: 7
    Latest Threads: 08-13-2003, 03:13 AM
  4. FS: Toshiba PDR-2300 Digital Camera 2.0MP

    By Smokem in forum Miscellaneous Buy/Sell/Trade
    Replies: 5
    Latest Threads: 05-06-2003, 12:42 AM
  5. Replies: 9
    Latest Threads: 02-12-2003, 01:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •