I had this same problem and I was able to make it work using DZMX1 Leviton Dimmer and a VP00R-10Z (no LED). You need to make sure you get the no LED model as this one only needs a neutral wire and not a hot.
- Then you have to make a couple changes to the light fixture. Your light fixture should have a neutral on one side and then the return hot from the remote switch.
- Remove the hot from the light fixture coming from the remote switch and un-do the wire nut that carries the hot to the remote switch.
- Connect this Hot wire the light fixture. Now its connected like a traditional one way switch.
- On the wires going to the remote switch, leave the traveler wires connected and pig tail the neutral wire to the neutral wire going to the light fixture.
- Tape off the hot wire going to the remote switch as it won't be used.
- At the remote switch connect the traveler wire and neutral wire as shown in the instructions and tape off the black wire and leave it unused.
- Document this somewhere because its going to confuse you later...
This is assuming your light is currently wired like this which it probable is:
https://www.easy-do-it-yourself-home...4M3S8JN4zX.jpg
Here is the Leviton instructions for reference. Look at step 4b.
https://cache-m2.smarthome.com/manuals/2016.pdf
Disclaimer:
I am not an electrician and I am sure this is against code. I am not responsible for anything that may happen because of this....