Garage door guy?

[LilDrunkenSmurf]

This quote is hidden because you are ignoring this member. Show Quote

Tony at best doors is the guy.

Still this.

[Buster]

Has anyone used Equal Doors?

https://www.equaldoor.com/

An architect friend suggested them.

[suntan]

They're the same.

Looks like they sell wood or steel doors?

[max_boost]

This quote is hidden because you are ignoring this member. Show Quote

Has anyone used Equal Doors?

https://www.equaldoor.com/

An architect friend suggested them.

I think it safe to trust your architect fwend

[eblend]

This quote is hidden because you are ignoring this member. Show Quote

Has anyone used Equal Doors?

https://www.equaldoor.com/

An architect friend suggested them.

I didn't use them directly, but they are who my builder deals with, and that is where I went to pick out my doors that I wanted. No complaints.

[AndyL]

This quote is hidden because you are ignoring this member. Show Quote

Has anyone used Equal Doors?

https://www.equaldoor.com/

An architect friend suggested them.

Equal's the local manufacturer for basically all the wood doors in alberta... I put them into the hit/miss camp - more luck of the draw around the quality of the wood you end up with than anything they personally do (other than maybe less than adequate QA/QC on the wood they build those doors with).

Architects are influenced more by who's taken them for lunch lately with a show & tell presentation, than actually knowing the product.

[Cash Money Hoes]

This quote is hidden because you are ignoring this member. Show Quote

Has anyone used Equal Doors?

https://www.equaldoor.com/

An architect friend suggested them.

I was recommended to use them as well. Their price was quite a bit lower for a specific CHI door we were after vs. the other local distributor. Cannot comment on quality of install as it has not gone in yet.

[littledan]

Bump.

My buddy came over to visit and tried to nose into my rear alley apron and sideswiped my garage door. Looks like 1 panel is pretty fucked and a second panel has a minor scrape. Can I get just that 1 or 2 panels replaced? Approx cost? Or do I need to buy a full new door?

I was thinking about the mismatch but if I can get away with a single panel maybe I just repaint the door to save cost as my friend is paying for the damage so want to get it as cheap as possible.

Standard builder grade flat panel door

[ExtraSlow]

Yeah you should call a garage door guy.

[AndyL]

Definitely.

The replacement panel vs whole door thing is still very much a reality - except a very limited few cases a single panel wholesale cost is about 2/3rds the price of a replacement door. And they usually arrived damaged. To enrage everyone for some reason during covid it seems like half the manufacturers changed the embossing patterns too.

Aka get a quote but don't be surprised if it ends up being a whole door.