LF: 10' Aluminum Brake for 30min

[mr2mike]

Looking to put a 90° bend on 17 pieces of J channel.
Can't find an aluminum brake that fits 10' lengths.

Anyone got a lead on one to borrow?
Willing to pay for the time, use, etc.

Thanks.

[gretz]

This quote is hidden because you are ignoring this member. Show Quote

Looking to put a 90° bend on 17 pieces of J channel.
Can't find an aluminum brake that fits 10' lengths.

Anyone got a lead on one to borrow?
Willing to pay for the time, use, etc.

Thanks.

If you’re willing to travel to aldersyde / high river, I know daver at 3d industries has one and my buddy at hot rod fabrication also does

[mr2mike]

I'll give it a bit, see if others are closer.
If not, I'll email you or text and we can figure it out. I can drive the pieces out there.

[legendboy]

This quote is hidden because you are ignoring this member. Show Quote

Looking to put a 90° bend on 17 pieces of J channel.
Can't find an aluminum brake that fits 10' lengths.

Anyone got a lead on one to borrow?
Willing to pay for the time, use, etc.

Thanks.

I have a brand new 12' Accurpress (foothills), if you can drop the material off I can have it bent up for you same day or next

[mr2mike]

Change of plans. Went to measure my existing aluminum fascia to determine where to put this bend.
None of it was remotely straight. I'd have a wandering gap up to half an inch which would look brutal.
Going to mount it differently and not need a bend.
I'll post pictures and it'll make sense.