I have a problem and i'm not sure how to fix this.
I installed an aftermarket power window kit today. Everything works well, but when I was testing the motors to make sure they went up and down, I noticed this:
To go up, you touch the red wire to a power source, and the negative to a ground.
To go down, you touch the ground wire of the window motor to a power source, and the red wire of the window motor to a ground. (basically reverse)
Now, I have a switch but i'm unsure how I am supposed to wire this to make them go both up and down. I can make them go up, but not down.
My question is:
1) Can I use the existing switch to make them go up and down (I prefer to do this, looks factory)
2) where do I draw power and ground from?
If someone can walk me through this it would be truly appreciated!