How should I hook up this sub & amp?

[punky]

AMP
KenWood KAC-7251

800 Watts max power
150 Watts x 2 max (4 ohms) RMS
460 Watts x 1 (4 ohms) RMS
Power Output at 2 Ohms, at 14.4V (1kHz, 0.8% THD): 230 Watts x 2

Bass boost via wired remote control
Frequency response 5Hz to 50kHz
Built in low pass filter (150Hz)
Built in variable high pass filter (50 - 200Hz)
Speaker level input
Gold plated input & output terminals
Integral cooling fan

SUB
Alpine SWR-1221D (12") Dual Coil
Max Output Power 1000 Watt
Nominal Output Power 300 Watt
Sensitivity 87 dB
Response Bandwidth 24 - 1000 Hz

How should i hook this up? One coil to each channel?
Bridge amp then connect coil in Series?
Any recommendation would be great. (im pretty newbie at this.)
Schematic would be great, otherwise descriptions work as well.

[punky]

Anyone? anyone?

[punky]

If it's 2ohms stable, Could i plug each channel into a coil?
And how do i put it to 2ohms/ channel?

[Simple]

Originally posted by punky
If it's 2ohms stable, Could i plug each channel into a coil?
And how do i put it to 2ohms/ channel?

Try this:

http://www.rockfordfosgate.com/rftech/wiringwizard.asp

Basically you have 2 options:

[Simple]

Or:

[Simple]

Since the AMP you selected (KenWood KAC-7251) can ONLY output to one channel stably in 4ohm mode, I would strongly recommend option # 2.

[punky]

sweet, thx, that answers my questions.
Once again thx very much