Registered User
B16a Swap into 1990 Integra
Hi,
A friend of mine with a 1990 Integra RS just bought a B16A off of eBay. I was wondering if there's any good resources on the Internet for this specific swap that someone could point me to.
I've seen Eric Bauer's write up on the CRX and I know most of it is similar, but I was wondering if there was anything that was unique to this swap.
Thanks.
Last edited by SanmaX42; 06-28-2004 at 08:56 PM.
Registered User
go to www.g2ic.com
Registered User
I did one of these swaps. Its pretty much a straight bolt in. Its just the 4 extra wires to the ECU you have to run. The hardest part was tracking down pins to plug into the ECU!
C.J.
1997 TSi AWD 2.3L 6 bolt (Carillo Rods, Wiseco pistons, Cometic headgasket, ACL bearings, removed BS, FP3's, Crower springs/retainers, ARP hardware), FIC 950's, Aeromotive AFPR with SS lines, Walbro 255HP, PTE SCM61, Tial wastegate, Greddy Type S BOV, short route FMIC, 3" turbo back, AEM EMS, 3 bar map conversion, BJs SMIM, 75mm TB, Innovate LC-1 Wideband, 18" Focals, Bridgestone Potenza RE040's, Tokiko suspension.
Registered User
ouch a b16a from ebay...how much did that cost in total?
Registered User
I'm not sure I think about $1500 after shipping. Came with ECU, tranny, and a few other perks.
Why, where can you get them for cheaper?
Registered User
Also,b16Ateg thank you so much for referring me to that site/group. That is such an amazing resource. The TEG TIPS were exactly what we needed. This is going to be a tough job, but at least we know the direction we're heading in now.
Registered User
oh nm, i thought you were from calgary. theres a site www.jdmsource.ca and they sell them there cheaper than ebay.
Registered User
ya no problem dude... just helping out a guy that wnats to put a b16a in a 90 teg.. cos thats what i got and am running
Posting Permissions
Quote