I have them, no issues.
There is about a cm if overlap on either side when are in the sheer setting. So if it isn’t lining up i just adjust slightly manually.
When you adjust it manually, are you raising it up by a few inches or so to allow for proper overlap? If so, im assuming the bottom of the window now isnt covered for privacy?
As for too much material, don’t lower them lower than the window goes and the material stays rolled up too and as such no excess fabric?
If we dont lower it all the way, there are gaps in between each band. If we raise it a bit to achieve 1cm overlap, now the bottom isnt covered..cant win
Is there a way to adjust them looks like your fabric just needs to be moved on the roll by about half an inch?? Might be on your installer hence the repeated fuck ups?
They come straight from hunter douglas like this. The roll gets shipped to the installer, they come and it basically just clips onto the top frame/bracket, few minute job.
I have them on about half a dozen windows and it’s really been no issue.