Information needed for 1JZ or 2JZ engines

[lowetyle]

A planned swap is in the works, but without a 2JZ or 1JZ (What I prefer right now) infront of me, I dont know what to do about engine mounts.

The engine will be replacing another Straight-6, so thats why I am leaning towards Toyota's powerplants.

What I need right now is information on the size and engine mount locations on these engines, to try and get the project vehicle ready for a drop.

I know there a ton of guides on the internet of people's projects dropping these engines into other Lexus and Toyota chassis', but I can gaurentee without question that there is not going to be a guide as to what my plans are right now.

So, if anyone has technical drawings, blueprints, or specs, or knows where I can get these (Without spending a fortune), it would be much appreciated.

Thanks!

[DonJuan]

What vehicle were you planning on dropping this into? That may help in searching for a swap guide.

[lowetyle]

The vehicle is domestic and over 50 years old.

[Annoyingrob]

IIRC, there are two placement points to bolt the mounts to on the block (you can use either set). One set around the #5 cylinder, and another around the #2 cylinder.

It'll be a LOT easier to just fab it up with the motor itself rather then going off of measurements, but I could give you measurements if you really want.