Originally Posted by
KPHMPH
I do not, just pressure load up to 20psi in the tank.
Any moment in the fluid is enough to liberate the gas, the fluid temperature was right around 70 coming from the hole to the test tanks then almost immediately pushed into our tanks.
Yes, 40,000 ppm. 2 weeks ago I was on a well pushing 14% sour. At those numbers you test the fluid daily for the %’s to make sure you have an air crew on standby while loading your truck if anything goes wrong.
I’m not an expert by any means on the chemistry of the fluid I mearly go by what I’m told by the MSDS and dangerous goods paperwork before I load. It’s updated daily on these sites because the %’s are always changing.
Interesting. This is rough googling but I found 60degree water can only hold 1.5g of pure H2S within 1000g max solubility.
So like .15%, or 1500ppm. Is my marth right?
I’m no expert either, and oil field work is dangerous. I’m always putting my teams through hazards assessments and field level assessments. Good to ask questions.
I’m guessing you’re getting gas and water as a fluid, not just water. The rig (assuming) could bleed it off, no?
Just be safe. The more you know the better equipped your are.
"The most merciful thing in the world, I think, is the inability of the human mind to correlate all its contents... some day the piecing together of dissociated knowledge will open up such terrifying vistas of reality, and of our frightful position therein, that we shall either go mad from the revelation or flee from the light into the peace and safety of a new Dark Age."
-H.P. Lovecraft